frame type hydraulic pressThere is no need for a special foundation. When the hydraulic press is in place, it is only necessary to level the bottom of the hydraulic press and adjust the work to this correction level. The process is very simple. Usually, after the hydraulic press manufacturer is installed in place, it is necessary to notify the professional debugging personnel of the hydraulic press manufacturer to carry out the cylinder lifting adjustment. If the user debugs himself, the following work should be done. Now, a brief introductionGantry hydraulic pressThe process of lifting the cylinder by the manufacturer and the points that need attention are for your reference only.
1. When lifting the main cylinder of the gantry hydraulic press, the main cylinder of the hydraulic press should be lifted in place by a jack, and then fixed firmly with bolts.
框式液压机
2. After installing the main oil cylinder of the hydraulic press, fix the filling oil tank and connect the inlet and outlet oil pipes of the filling valve with bolts.
3. After the main oil cylinder of the hydraulic press and the filled oil tank are in place, connect each oil pipe according to the label number on each hydraulic oil pipe and the oil pipe connector.
4. Carefully check whether each connection position of the gantry hydraulic press and the hydraulic oil pipes have been firmly connected. Only after all are correct can the next test run be carried out.