1、1200 ton hydraulic presstheir own adjustment.
Before installation, you must first adjust the performance of the equipment. This process must be carried out carefully and patiently to check whether the oil press enters dust, powder, iron debris, etc., and carry out necessary cleaning, which can reduce many troubles in the later period.
2, about1200 ton hydraulic pressAdjustment of the slider stroke.
Attention should be paid to check the thickness of the mold, but also to check whether the proportion of the upper and lower modules is normal. Under normal circumstances, the module should be controlled at the switch point of the stroke line, which should be paid more attention.
3. Adjustment of stroke module of 1200 ton hydraulic press.
The hydraulic press can be adjusted to the high point, that is, the upper limit point of the module can be adjusted accordingly. When the module reaches the high position, the switch should be set up, and the staying position of the slider should be reserved. At the same time, the deceleration module should be carried out when the module is going down to better protect the equipment and mold.
4. Adjustment of the gap between the 1200-ton hydraulic press.
It is mainly to measure the distance between the upper module and the lower module first, and the specific gap setting needs to be determined according to the pressed plate.
5. Adjustment of the angle of the 1200-ton hydraulic press.
The adjustment of this angle is also related to the products produced. Generally speaking, if the mold is folded 90 degrees, the angle in the middle must be greater than the angles on both sides. Its tightness can be carried out according to the adjustment screw. When bending, the pressure can be adjusted through the pressure gauge to avoid die chipping.