Many customers said they would only use it.single-arm hydraulic pressHowever, it will not be repaired. I don't know when to change the hydraulic oil. This is not possible. We can properly repair it by checking the five aspects of the single-arm hydraulic press.
single-arm hydraulic pressThe five checks:
1. External overall inspection: clean the outside of the machine tool, and then look at whether the screws are loose, whether the parts are, whether there are cracks or deformation. The length of the mark on the fuselage shall not be less than 30cm;
2. Inspection of the clutch device: The inspection of the clutch should be carried out during operation. Look at the wear of the wave teeth. If it is worn out by 1/3, it must be replaced;
3. Test run inspection: When the machine tool rotates, we need to see if there is any air leakage, and also to see if the machine has abnormal vibration and lubrication;
4. Inspection and adjustment of forging parts: When conducting a pressure test, we can use a relatively high pressure to detect the stroke of the piston. There should be no leakage in the oil circuit. After the pressure is removed, the pressure gauge will return to 0. At this time, the parts are not damaged;
5. Inspection of the input device: the conveyor chain should be inspected one by one. If there is serious wear and deformation, we should replace it. The tension of the chain should be the same, as far as possible, the chain length can slightly touch the lower plate.
To sum up, the five inspections of the single-arm hydraulic press are the external overall inspection, the inspection of the clutch device, the inspection of the test run, the inspection and adjustment of the forging parts, and the inspection of the input device. I hope these contents will be of some help to everyone.