CNC lathe can efficiently machining high precision turning workpiece, processing methods also have drilling, turning wire and other functions. It is suitable for metal materials, broken shaft products and parts of plumbing and sanitary ware industry. It is an ideal equipment for processing complex shaft small parts with simple programming and high machining precision. When using the turn-milling compound CNC lathe, ensure a constant level of ambient temperature. The available ambient temperature requires 10-40 ℃. When the ambient temperature is 20 ℃, the humidity should be 40-75%. In order to keep the static accuracy of the machine tool within the specified range, the ambient temperature is required to be 15-25 ℃, and the 24h temperature difference shall not exceed ± 2. If the voltage is unstable in the area of use, the machine tool should be equipped with a regulated power supply to ensure the normal operation of the machine tool. Lathe should also have a reliable grounding, grounding wire for copper wire, wire diameter should not be less than 10mm ², grounding resistance is less than 4 ohms.
CNC lathe daily use should be away from direct sunlight, vibration source and heat source, to avoid too wet, too much dust or corrosive gas places. Corrosive gas is easy to make electronic components by corrosion, resulting in poor contact or short circuit between components, affecting the normal operation of the equipment. Precision numerical control equipment should be far away from large vibration equipment, such as punching machines, forging equipment, etc. The equipment should not be sealed for a long time. The machine tool control system should be fully utilized after purchase. In the first year of use, the weak links prone to failure should be exposed as soon as possible and eliminated during the warranty period. In order to ensure the normal working performance of the equipment, if the compressed air source does not meet the requirements of the air source, a set of air source evolution device should be added before the air intake of the machine tool. When there is no processing task, the CNC lathe should also be powered on regularly, 1-2 times a week, and each time it runs dry for about 1 hour, so as to use the heat of the machine itself to reduce the humidity in the machine, so that the electronic components will not be affected with moisture, and at the same time, it can also find out whether there is a battery alarm in time to prevent the loss of system software and parameters.