1, prohibit no work experience personnel controlCattle and sheep brick licking hydraulic pressNew employees should be trained before taking up their posts.
2, found that machinery, mold abnormalities in a timely manner to report, to repair qualified rear production.
3. Overcome carelessness and illegal operation, and prohibit more than two people from operating the cattle and sheep licking brick hydraulic press at the same time. (Before starting, check whether each fastener is firm, whether there are obstacles in each running part and sliding surface, and whether the limiting device and safety protection device are perfect.)
4, mechanical repair, maintenance must cut off the power supply, pad on the sleeper.
5. During the operation of the hydraulic press, it is strictly forbidden to enter the mold cavity to repair the mold, and strictly pay attention to safety when entering and leaving the product. Use the safety device to move the product to the side first, and then use your hand after confirming the safety.
6. The installation mold must be standardized. After the pressure plate is pressed, check it again. The closing height of the press should be controlled within an adjustable range. The pressure of the press should be adjusted from small to large. The first piece must be inching.
7. Tools, pressure plates, screws, nuts and cushion blocks should be handled gently and placed on the shelf after use.
8, in accordance with the provisions of the lubrication chart to add lubricating oil, check the amount of oil, oil is smooth, oil quality is good. (It is forbidden to adjust the regulating valve and pressure gauge randomly, and the pressure gauge should be calibrated regularly. Keep the oil quality of the hydraulic oil, and the temperature of the working oil should not exceed 45 ℃. If there is any abnormality, stop the machine immediately.)
9. Check whether the fasteners of the cattle and sheep licking brick hydraulic press are firm, and whether the limiting device and safety protection device are complete and reliable.
10, cattle and sheep licking brick hydraulic press for idle stroke test run; Check whether each button, switch, valve, limit device, etc. is flexible and reliable; Only after confirming that the pressure of the hydraulic system is normal and the movement of the working beam is flexible can it work.