Sagger hydraulic press debugging steps are as follows:
Preparation: Confirm whether the hydraulic system, electrical system and machine parts work normally, whether the hydraulic oil is sufficient, and clean the machine and working area.
Install and adjust the upper and lower molds: select the appropriate upper and lower molds according to the needs, and install them on the hydraulic press. Adjust the mold height, levelness and installation tightness to ensure that the mold is well assembled.
Adjust the machine: According to the processing requirements and the size of the workpiece, adjust the stroke, pressure, speed and other parameters of the machine to ensure that the machine can work normally and meet the processing requirements.
Start processing: Start the machine and let it run automatically, or manually control the machine for processing. During processing, pay attention to observe the running status of the machine and pay attention to whether there are abnormal conditions, such as abnormal noise, leakage, etc.
Adjust the mold: According to the actual situation in the processing process, fine-tune the mold to ensure the processing quality and processing efficiency.
Shutdown: When the processing is completed, stop the machine and press the shutdown button to turn off the hydraulic system.
Unloading the workpiece: Unload the workpiece from the workbench and clean the work area.
Maintenance: Regularly check whether the parts of the machine are working properly, keep the hydraulic system clean and lubricated, replace the hydraulic oil in time, and maintain the hydraulic cylinder.
In short, the commissioning of the sagger hydraulic press needs to pay attention to safety, abide by the operating procedures, understand the machine performance and processing requirements, ensure the normal operation of the machine, and carry out necessary maintenance. If you are not familiar with the operation, it is recommended to ask professional and technical personnel to operate.