What are the precautions for the 1000 ton hydraulic press in the mold test?

1000 tons of hydraulic press type mold should pay attention to the following points:
1, before the mold, to put1000 tonsAfter the sliding table of the hydraulic press rises to the top, the oil pump is stopped. Raising the sliding table to the top is convenient for us to put the mold.
2. After placing the mold on the worktable of the hydraulic press, we need to see if the mold is in the center of the worktable. The mold should not be biased. After the mold is located, fix the mold.

3. Fixing the mold. Our hydraulic press has a T-groove, which is specially used to fix the mold. It is OK to fix the mold with a T-screw and a pressure plate.
4. After the mold is fixed, we can formally test the mold. Automatic mode mode mode is not available for formal test molds. Manual mode mode mode mode must be used to deal with inappropriate problems.